OPERATION
18
Problem EasyRise Shadings Only: The universal cord tensioner grabs onto the cord
upon operation.
Solution
Check that the universal cord tensioner is mounted properly. Reinstall, if
necessary.
Problem. LiteRise
®
Shadings Only: Vanes will not open.
Solution With your thumb on the front of the handle and fingers on the back, gently pull
the back of handle down and away from the shading to open. The shading must
be fully lowered to tilt itopen.
Problem UltraGlide
®
2 Click and Walk Away
™
and UltraGlide Shadings Only: The
tassel cord and lower cord connector have detached from the upper cord
connector.
Solution To Reattach the Tassel Cord:
■ Hook one side of the lower cord connector
to the upper cordconnector.
■ Rotate the lower cord connector until it
snaps intoplace.
■ Twirl the tassel cord to pull any stray
cord fibers out of the junction of the cord
connector halves. Stray fibers in the junction
may cause the connector to come apart.
Upper Cord
Connector
Lower Cord
Connector
Tassel Cord
(Attached to
the Lower
)
To Next Page
Loading...
Need help?
General
