Hunter 50 - Out of Water Inspection

Hu
nt
e
r
50
• D
ocu
m
e
nt
s
a
n
d
F
o
rm
s
2.4
P
re
li
m
i
nar
y
care an
d
ma
i
ntenance c
h
ec
kli
s
t
A qualified Technician should be used if you are not completely confident in your ability to
m
ake repairs or inspections
.
Out of Water Ins
p
ection
Pre-launch ins
p
ection
____
Sacrifi cial zinc anodes installed
_
___ Propeller installed with keyway, nuts and cotter pi
n
_
___ Propeller shaft turns freely and without excess wobble
____
Struts and shaft lo
g
free of corrosio
n
_
___ Rudder swings easily & correct with wheel directio
n
_
___ Rudder and post inspected for cracks and/or concealed damage (may require removing rudder
)
____
Auxiliar
y
tiller handle properl
y
ali
g
ned, fi ts securel
y
and operational
_
___ All thru-hulls and valves below water line inspected for corrosion, labeled and closed until after launch
_
___ Bottom paint in satisfactory condition
____
Hull freshl
y
cleaned and waxed (free of
g
elcoat dama
g
e)
_
___ Mooring, safety lines and fenders onboard and in good condition
_
___ House & engine start batteries installed and fi lled with correct electrolyte level
s
____
House & en
g
ine start batter
y
boxes secured
_
___ All battery terminals clean and wires secured
_
___ Engine block & transmission drains closed
____
Speed / Depth transducers in place. Speed paddle wheel rotates smoothl
y
_
___ Hose clamps on all systems below water line tight
_
___ Keel bolts tight and clea
n
____
Exhaust hose attached and secured
_
___ Boat is free of internal and external water leaks above water line
(Failure to stop water intrusion could result in permanent damage or deterioration of structural coring materials, internal wiring and cause mildew and molding)
M
ast Assembl
y
____
Review manufacturers manual for maintenance and up-keep
_
___ Spreaders securely fastened
_
___ Mast and spreaders free of corrosion and stress cracks
____
Standin
g
ri
gg
in
g
and pins inspected for wear, tear, corrosion and crackin
g
_
___ External wiring secured for anchor, steaming and deck light
s
_
___ Electronic wind indicator installed per manufacturers recommendation
____
Manual wind indicator installed on masthead
_
___ VHF antenna installed and connected
_
___ Headsail furling system installed inspected per manufacturers recommendatio
n
____
Runnin
g
ri
gg
in
g
inspected for wear and tea
r
_
___ Mast step stand-up blocks secured and operational
_
___ Main Sail, jib sail and fl aking system inspected for wear and tear (non-furling mast).
____
In- mast s
y
stem checked for smooth operation and overall condition of sail
s
_
___ Specifi ed pre-bend and diagonal tensions attained in mast. See owners manual
_
___ Mast to deck wiring properly sealed with drip loop