Hunter 50 - In Water Inspection

Hu
nt
e
r
50
• D
ocu
m
e
nt
s
a
n
d
F
o
rm
s
____
Rubrail sealed secured to hull
_
___ Sliding hatches drains free of debris
_
___ Companionway drop-ins fi t properly in companionway and stowage rack
____
Load bearin
g
hardware securel
y
fastened. This includes but is not limited to chainplates, winches and handrail
s
_
___ Traveler arch securely fastened. Stainless Steel models should be properly grounded
See owners manual for details
____
Plexi
g
las hatches, ports, windscreens and windows ad
j
usted and cleaned
.
Cleaners and polishers specifi cally for Plexiglas can be purchased from most marine supply stores
_
___ External teak cleaned and oiled (Teak decking cleaned with mild soap and water
)
____
External railin
g
s cleaned with soap and water then hand polished usin
g
automotive wax
_
___ All deck fi ll caps seal properly and have retainer chains intact (except Waste Pump-out)
_
___ Dorade vents or sealing caps installed
____
Topside surface clean and free of
g
elcoat dama
ge
Interior Ins
p
ection
____
Drop-in hatches for bunks and fl oors in place and fi t securel
y
_
___ Interior steps and grab rails secured
_
___ Bilges clean and free of debris
____
Openin
g
port and hatch screens in plac
e
_
___ Blinds / privacy curtains, shades and interior cushions cleaned, installed and secured
_
___ All doors open / shut / latch properl
y
____
Insure all wires and connection on distribution panels are ti
g
ht (should be
professionally inspected)
_
___ Television / VCR operational
____
Stereo / Tape / CD operational
_
___ Chapman’s Manual onboard and readily availabl
e
_
___ Safety gear onboard readily available and up to date.
See Chapman’s Manual and US Coast Guard website at < www.uscg.mil >for details.
_
___ Boat owner’s manual onboard
In Water Ins
p
ection
D
ockside inspection of En
g
ine, Pre-start sequence and operatin
g
s
y
ste
m
_
___ Review engine manual for maintenance requirements and proper starting procedur
e
_
___ Propeller shaft properly aligned (per engine manual
)
____
Shaft to en
g
ine couplin
g
bolted and properl
y
torque (per en
g
ine manual)
_
___ All engine mounting bolts in place and properly torque (per engine manual
)
_
___ Crankcase oil at full mark (per engine manual)
____
Transmission fl uid / oil at full mark (per en
g
ine manual)
_
___ Coolant mix ratio proper - heat exchanger and expansion tanks full (per engine manual)
_
___ Seawater intake valve open and no leak
s
____
Air bled from fuel lines and s
y
ste
m
_
___ No fuel leaks at any fi ttings
_
___ Throttle linkages smooth and operational
____
Shutdown s
y
stem operational
_
___ USCG Oil Discharge warning poster in plac
e
_
___ Exhaust elbows and hoses tight
____
Startin
g
sequence and alarms correct
_
___ Oil pressure acceptable (per engine manual)
_
___ Coolant temperature acceptable (per engine manual)
2.
7