nt
r
• D
m
nt
n
F
rm
2.
Alternator DC output at rated rpm (per en
ine manual)
____ Correct Idle rpm (per engine manual
____ Water discharged with exhaust
Hour meter operational
____ Fuel level indicators operational
____ Throttle cable tension set properl
Shifter operation correct
____ Neutral safety start switch operational
____ No inboard exhaust gas leaks
No fuel / oil / water leaks on en
in
____ Shaft packing / Drip free Seal ad
usted and locknuts tight.
One to three drips per minute with shaft turning on traditional packing assembly
En
ine box installed and secured
ockside inspection of Generator, Pre-start sequence and operatin
s
stem
Review and follow manufacturer’s manual for maintenance and up-keep
____ Seawater strainer water-tight and clea
____ No leaks in fuel system - Fuel fi lters clea
Lube oil at full mark
____ Coolant level full - proper mix ratio with water (per generator manual
____ Seawater discharge overboard with exhaust gas
No inboard water or exhaust
as leak
____ Proper voltage output to distribution panel (per generator manual
____ Ship / Shore power transfer panel function properl
Starter batter
box secured
____ Starter battery cable connections clean and tight
____ Starting battery electrolyte level prope
Climate Control S
stem
____ Review and follow manufacturers manual for maintenance and up-keep
Seawater strainer water ti
ht and clea
____ Seawater pump air purged and operational
____ Seawater fl ow adequate fwd and aft
Fwd s
stem functions properl
in all modes of operatio
____ Aft system functions properly in all modes of operatio
____ No seawater leaks in system components and lines
No condensation leaks to deck or liner
____ Air return/intake fi lters clean and clea
____ 110 or 220 VAC shore power wired correctly at doc
Remote control units and displa
features operate correctl
____ Condensation drains open
re-de
arture Checklis
Check bil
e for extra wate
____ Check weather conditions and tide
____ Check food Suppl
Foul weather
ea
____ Linen, sleeping bags
____ Fuel