IMPORTANT SAFETY INSTRUCTIONS
Read all instructions before operating the GSP9200.Read and follow the instructions and
warnings provided in the service, operation and specification documents of the products with
which this GSP9200 is used (i.e., automobile manufacturers, tire manufacturers etc.).
Do not operate equipment with a damaged cord or equipment that has been dropped or damaged
until a Hunter Service Representative has examined it.
Always unplug equipment from electrical outlet when not in use. Never use the cord to pull the
plug from the outlet. Grasp plug and pull to disconnect.
If an extension cord is necessary, a cord with a current rating equal to or more than that of the
equipment should be used. Cords rated for less current than the equipment may overheat. Care
should be taken to arrange the cord so that it will not be tripped over or pulled.
Verify that the electrical supply circuit and the receptacle are properly grounded.
To reduce the risk of electrical shock, do not use on wet surfaces or expose to rain.
Verify the appropriate electrical supply circuit is the same voltage and amperage ratings as
marked on the balancer before operating.
WARNING: DO NOT ALTER THE ELECTRICAL PLUG. Plugging the electrical plug
into an unsuitable supply circuit will damage the equipment and may
result in personal injury.
To reduce the risk of fire, do not operate equipment near open containers of flammable liquids
(gasoline).
Read and follow all caution and warning labels affixed to your equipment and tools. Misuse of this
equipment can cause personal injury and shorten the life of the balancer.
Keep all instructions permanently with the unit.
Keep all decals, labels, and notices clean and visible.
To prevent accidents and/or damage to the balancer, use only Hunter GSP9200 Series Vibration
Control System recommended accessories.
Use equipment only as described in this manual.
Never stand on the balancer.
Wear non-slip safety footwear when operating the balancer.
Keep hair, loose clothing, neckties, jewelry, fingers, and all parts of body away from all moving
parts.
Do not place any tools, weights, or other objects on the safety hood while operating the balancer.
ALWAYS WEAR OSHA APPROVED SAFETY GLASSES. Eyeglasses that have only impact
resistant lenses are NOT safety glasses.
Keep the safety hood and its safety interlock system in good working order.
Verify that the wheel is mounted properly and that the wing nut is firmly tightened before spinning
the wheel (or AutoClamp is engaged and secure).
The safety hood must be closed before pressing the green “START” key, located on the right
front corner of the console, to spin the wheel.
Hood Autostart will cause the balancer shaft to spin automatically upon hood closure. For the
next Autostart, the safety hood has to be lifted to the full up position and then closed.
Raise safety hood only after wheel has come to a complete stop. If safety hood is raised before
the spin is completed, the weight values will not be displayed.
Do not let cord hang over any edge or contact fan blades or hot manifolds.
The red “STOP” key, located on the right front corner of the LCD assembly, can be used for
emergency stops.
DANGER: Never reach under the hood while the balancer is performing a runout
measurement or balance spin.
SAVE THESE INSTRUCTIONS
2
1. Getting Started GSP9200 Series Wheel Balancer Operation Instructions
To Next Page
Loading...