Hunter GSP9200 Series - 2.5 WeightSaver Wheel Balancing Feature

The screen will display the amount and location of corrective weight necessary.
Install the weights in the appropriate manner using the correct type of weight and
lower the hood to re-spin and check the balance. Instead of displaying zeros in the
weight display, SmartWeight
®
displays “OK,” indicating that the force levels are
reduced to within the acceptable tolerances.
Switching from SmartWeight
®
to Traditional Dynamic Balancing Modes
At any time, SmartWeight
®
can be switched to standard balancing as long as both
standard and SmartWeight
®
modes are enabled in setup.
Press the knob until SmartWeight
®
is highlighted. Once highlighted, press and hold
the knob till the standard balance icons appear. Cycle back the same way.
2.5 WeightSaver
®
Wheel Balancing Feature
Essentially, SmartWeight
®
sets limits on the forces. WeightSaver
®
adjusts the
percentage of these forces to either save weight, or have a more fine-tuned balance.
With SmartWeight
®
, and bar graph in the green is within acceptable limits.
WeightSaver
®
allows that bar graph window to be changed.
The WeightSaver
®
wheel balancing feature is a percentage of the force limit
intentionally left in the assembly to save weights.
The lower the value favors a lower residual force and a higher value favors weight
savings. The following example is set at the default of 75%. A 75% residual goal
means that WeightSaver
®
allows 75% of the maximum allowed couple force to
remain. This saves more weight, saves time, and saves money.
GSP9200 Series Wheel Balancer Operation Instructions 2. Balancing Overview
x
5