1. Getting Started
1.1 Introduction
This manual provides operation instructions and information required to operate the
GSP9200 Series Balancer. Read and become familiar with the contents of this
manual prior to operating the GSP9200.
The owner of the GSP9200 is solely responsible for arranging technical training. The
GSP9200 is to be operated only by a qualified trained technician. Maintaining records
of personnel trained is solely the responsibility of the owner and management.
This manual assumes the technician has already been trained in basic balancing
procedures.
References
This manual assumes that you are already familiar with the basics of tire balancing.
The first section provides the basic information needed to operate the GSP9200. The
following sections contain detailed information about equipment operation and
procedures. “Italics” are used to refer to specific parts of this manual that provide
additional information or explanation. For example, Refer to “GSP9200 Components,”
page 8. These references should be read for additional information to the instructions
being presented.
1.2 For Your Safety
Hazard Definitions
Watch for these symbols:
CAUTION: Hazards or unsafe practices, which could result in minor
personal injury or product or property damage.
WARNING: Hazards or unsafe practices, which could result in
severe personal injury or death.
DANGER: Immediate hazards, which will result in severe personal
injury or death.
These symbols identify situations that could be detrimental to your safety and/or
cause equipment damage.
GSP9200 Series Wheel Balancer Operation Instructions 1. Getting Started
1
To Next Page
Loading...