Hunter Hydrawise Ready - Offline Mode - Advanced Offline Mode

!
Page 39
RC-024 Version 2.01
REPORT NAME
DESCRIPTION
Watering History (Actual)
Shows actual completed watering time for each zone. You
can hover over each watering time to see more details
about the watering.
Weather Forecast
Show the historical weather forecast plus the next 3 days,
forecast. You controller will use this forecast to adjust your
watering schedule.
Weather Station Temperatures
Shows daily maximum temperatures for each weather
station to which the controller is subscribed.
You can click on the weather station names at the bottom
of the report to show their information in the report or
exclude it.
Hover over any temperature bar to see further information
including the relevant time period and rainfall for that
period.
Weather Station Rainfall
Shows daily rainfall for each weather station to which the
controller is subscribed.
You can click on the weather station names at the bottom
of the report to show their information in the report or
exclude it.
Hover over any rainfall bar to see further information.
Weather Station Wind Gust
Shows wind gusts for each weather station to which the
controller is subscribed.
You can click on the weather station names at the bottom
of the report to show their information in the report or
exclude it.
Hover over any wind gust bar to see further information.
Evapotranspiration (ET)
Shows daily evapotranspiration for each weather station
to which the controller is subscribed.
You can click on the weather station names at the bottom
of the report to show their information in the report or
exclude it.
Water Saving
Shows the estimated water saving for your controller over
the last 7 days. During cold weather you would expect to
see this percentage increase due to reduced watering.
During hot weather you would expect to see this
percentage decrease (and go negative) as the controller
increases watering.
Flow Meter Measurements
If you have a flow meter installed, this report shows
reported flow for each of your controller’s zones.
Total Water Usage
Shows daily water usage as recorded by each flow meter.
Also shows minimum and maximum water usage for any
flow meter across the period as well as the average and
total water usage.
You can click on the flow meter names at the bottom of the
report to show their information in the report or exclude it.
Hover over any flow meter bar to see how many zones
were active at the time.