To Next PageTo Next PageWhat to do if my Hunter X-CORE XC-2 Controller display shows “ERR” with number ERR message?
If the display on your Hunter Controller shows “ERR” followed by a number, it typically indicates a short in the field wiring or a faulty solenoid. You should check the field wiring and valve solenoid to identify and fix the problem.
What to do if my Hunter X-CORE XC-2 Controller display shows P “ERR”?
If the display on your Hunter Controller shows P “ERR”, this indicates a short in the P/MV wiring or solenoid. Check the wiring and solenoid at the P/MV, and refer to the specifications for the Pump Start Relay.
How to fix a frozen or garbled display on my Hunter Controller?
If your Hunter Controller's display is frozen or garbled, it is likely due to a power surge. Try resetting the controller to resolve the issue.
What does it mean if my Hunter Controller display shows SP “ERR”?
If the display on your Hunter Controller shows SP “ERR”, it means that electrical noise is present near the connection to the remote or another SmartPort device. Move the connections away from sources of electrical noise, and verify that the controller has been wired correctly.
General| Brand | Hunter |
|---|---|
| Model | X-CORE XC-2 |
| Category | Controller |
| Language | English |
