HUNTER XC HYBRID QUICK CHECK AND RESET FEATURES
Clearing the Controller's Memory/Resetting the Controller:
If you feel you have misprogrammed the controller, there is a process that will reset the memory to the
factory defaults and erase all programs and data that have been entered into the controller.
Press and hold down the button.
Press and release the reset button in the lower wiring compartment.
Wait 2 seconds and release the button. The display should now show 12:00 AM. All the memory
has been cleared and the controller may now be reprogrammed.
Easy Retrieve™ Program Memory:
The XC is capable of saving the preferred watering program into memory for retrieval at a later time.
This feature allows for a quick way of resetting the controller to the original programmed watering
schedule.
To save the program into the memory:
With the dial in the RUN position, press and hold the and buttons for 5 seconds. The display
will scroll three segments from left to right across the display indicating the program is being saved into
memory.
Release the and buttons.
To retrieve a program that was previously saved into memory:
With the dial in the RUN position, press and hold the and buttons for 5 seconds. The display will
scroll three segments from right to left across the display indicating the program is being saved into
memory.
Release the and buttons.
To Next Page
Loading...
Need help?
General
