HunterDouglas PowerView Manual

6. Motor control button LED
The motor control button LED gives an indication of the motor status. The LED can ash RED or GREEN. Below you nd an
overview of all possible combinations.
5.10 Release the manual control button .
The motor LED turns off
5.11
Press and hold the  stop button for 6 seconds.
The remote will exit programming mode
automatically after 20 seconds.
Keep pressing until the remote lights stop
blinking
5.12 The slat open position is set!
Sequence Explanation
After power up
Restart / Start up
MANUAL
Page 20 of 24 version: 1.1

HunterDouglas PowerView Specifications

General

Power Source	Battery
Type	Remote Control
Technology	Radio Frequency (RF)
Battery Type	CR2032
Compatibility	Hunter Douglas motorized shades and blinds
Connectivity	RF
Buttons	Multiple
Dimensions	Varies by model
Weight	Varies by model