BASIC FUNCTIONS SECTION 5.13
LLOAD
5.13.9 Function LLOAD command allows the HUNTER to load Basic programs
through its serial port.
Syntax LLOAD
Examples LLOAD
Loads Basic source from the RS-232 port.
Remarks Programs which were output using LLIST onto a storage
medium, e.g. disk or another HUNTER may be reloaded using
this command. LLOAD is terminated by typing ESC. See
section 3,6, LOADING FILES, for a detailed description of
program loading/unloading options.
VEF. 'J09F
Be sure to check HUNTER's receiving parameters for compati-
bility with the device transmitting data.
LLOAD data goes into memory via the Basic interpreter input
routine and is syntax checked on the way - if errors or
spurious data are found in the incoming data, HUNTER will
stop loading and display:
* SYX Error
If this occurs at the start of a file, it is likely that
some header data, not in Basic syntax, has caused the
problem.
Simply type LLOAD again, quickly, as HUNTER's input buffer
will still be receiving data,
LLOAD does not echo incoming characters onto the screen.
PAGE 5 - 72
To Next Page