EDITOR
SECTION 7.4
SAVE
7.4.12 KEYS:
save
save
FUNCTION: This command is for saving modified text into a file.
After entering the command, the label line is cleared and
the message:
Save Filename
is displayed.
If 'Enter' is pressed immediately, the te,ct
is stored back into the file originally loaded. otherwise,
a new file is created with the text. However, if the
Editor was entered from Basic by simply pressing Edit and
then Enter, then a new file called 'HUNTER.HBA' will be
created unless a filename is specified.
If .HBA suffix is used, then the file will be assumed to be
a Basic source file. Any other suffix will always create a
text file.
REMARKS: If there is insufficient room, then DEMOS is re-entered and
the error message:
VER.V09F
Disk Full File length= n blocks
is displayed where n is the number of blocks needed to save
all the file currently in the Editor. By clearing
sufficient space in the HUNTER it is possible to save the
file in the Editor using the file manager command:
SA VE n filename
where n is the same number displayed in the error message.
This will happen even if the Editor was entered from Basic.
PAGET-19
To Next Page
Loading...