MAINTENANCE AND ACCESSORIES
SECTION 8.2
8. 2.1
8.2.2
8. 2. 3
VER.V09F
CASE SEALING
STANDARD Hlffl'l'ER
All HUNTER's are built with integral seals to provide a high
degree of protection against atmospheric moisture, corrosive
gases and accidental immersion, therefore HUNTER should not be
opened.
'lliE BATTERY SEAL
This is a small
1
0
1
ring seal running in a machined groove in
the battery plug and seating on a machined face in HUNTER
casting.
This seal requires a smear of silicon grease to assist in
seating.
SEAL SPECIFICATION
Dimension
Part no.
1 • 5mm X 30mm HUN-05710
Replacement seals may be obtained from HUSKY Computers or
authorised agents.
PAGE 8 - 2
To Next Page
Loading...