CCIIMUNICATIONS
SECTION
6.4
6,4
6.4.1
6.4.2
VER.V09F.
COMMUNICATION PORT SOFTWARE
HUNTER's communications format is software controlled.
If HUNTER fails to communicate, always check the port
initialisation for the correct format.
INITIAUSI~ 1lIE PORT
To initialise, or alter, HUNTER's communications parameters as
follows:
From
File Manager, 'COMS', or application program select
'Initialise communications'·
You are now in the communications program. All entries are
menu-type choices, selected by the cursor control keys and
confirmed by 'enter'.
Values previously selected are displayed as the initial menu
option presented. For instance, if
1
1200 baud' had previously
been selected, then this option will appear after the heading
'Rate',
HUNTER will prompt first for 'transmission parameters', followed
by 'Receiving Parameters'.
Specific parameters are modified by positioning the cursor with
the cursor left, cursor right keys, and selecting the desired
option with the cursor up, cursor down keys.
NOTE: If the HUNTER has been totally reset for any reason, the
parameters shown on entry to this program may differ from that
expected. Extended use of the cursor keys will always correct
any anomolies.
TRANSMISSION PARAMETER SCREEN
Transmission Parameters
Rate-1800 Prtcl-none
pty-none
CTS-n DTR-n LF-n Echo-y T/0-no Null-0
press ENTER if acceptable
PAGE6-6
To Next Page
Loading...