EDITOR
7,4,8
FIND
KEYS: Find
Find
SECTION 7.4
FUNCTION:
Find is used to seach the file for a specified string, The
search is only forward from the cursor position to the end
of the file. There is no search prior to the cursor.
After activating Find, the label line is cleared and the
message:
Find?
is displayed. The desired string is typed in (up to 68
characters). After pressing Enter, the search is started
and the message:
** Wait
is displayed. If an exact match for the desired string is
found then the cursor is placed on the first character.
If no match is found, the message:
** Failed
is displayed on the bottom line and the cursor returned to
its original position.
If it is desired to find the same string a second time,
then pressing only Enter after the "Find?" prompt will
cause the search to go on through the file looking for the
next occurrence. This should not be done for the first
search after entering the Editor as the command will be
rejected,
REMARKS: Find can be aborted by entering ESC,
The "failed" message disappears after any key depression.
VER.V09F.
PAGE 7 - 15
To Next Page
Loading...