APPENDIX
9.5.4
VER.V09F
SECTION 9.5
PROOR!M 4 'UNLOAD'
On the host computer type the following program into a text file
with the name UNLOAD.HEX. Before the file can be used it has to
be converted to a .COM file, to convert the file enter the
following command:
>LOAD UNLOAD.HEX
This will create a file with the name UNLOAD.COM and can now be
used to convert any file into INTEL HEX format. To convert a
file enter the folowing:
>UNLOAD sourcefile filename. HEX
The first file 'sourcefile' is the name of any file required to
be converted, the second file 'filename.HEX'
will then contain
the INTEL HEX version of the file.
The HEX format file will always be located at
1 OOH, but if all
transferred data is saved into new files, (with the SAVE n
command) then this is not a problem.
A source code version of UNLOAD is available on request from
Husky Computers or authorised agents, either as a listing or 8
11
IBM compatible disk.
PAGE 9 - 33
To Next Page
Loading...