English – 43
TANK UNIT
Replacing the tank vent valve, oil tank
334T, 338XPT:
1. Pull out the valve’s rubber fastener using a pair of pliers.
2. Fit a new pin, vyon plug and valve in a new rubber fastener,
place the unit in the hole in the tank from the outside.
3. Pull in the valve with fitted vyon plug and pin using a pair of
long-nosed pliers from inside the tank.
1. Pull out the vyon plug (G) by pushing in a screwdriver and
prising it out. Then pull out the plastic valve.
2. Fit the plastic valve and vyon plug, using the shaft of a
screwdriver to press the vyon plug in place.
G
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
Need help?
General
