Note: When you put the product into storage for a
long period, it is recommended to switch off the main
switch to save battery power. With the GeoFence
function on, a PIN code is necessary to switch off the
product. If you switch off the main switch, the
Automower
®
Connect stays on for 12 hours. After that it
is not possible to communicate with the product and the
GeoFence function is not on.
3.2 Symbols on the display
These symbols are shown on the display of the product
when Automower
®
Connect is enabled.
The signal strength of the GPRS
reception.
Problem with the connection to the
Internet server.
Problem with the SIM card or the module.
4 Operation
4.1 Main menu
•
Dashboard
: Shows the current status of the
product. It shows symbols for the battery status
and cutting height.
•
Map
: Shows the current position of the product and
the set centerpoint for GeoFence. You can monitor
the movement of the product with this function, for
example in case of theft.
•
Messages
(only available for Bluetooth
®
short-
range connectivity): In this menu the fault and
information messages can be found. For some of
the messages, there is information to help you to
correct the fault.
4.2 My mowers
My mowers
shows the status of the product, you can
remove or add products paired to the account.
5 Technical data
5.1 Technical data
Frequency Band Support
Automower
®
Connect 2G GSM 850 MHz, E-GSM 900 MHz, DCS 1800 MHz, PCS 1900 MHz
Automower
®
Connect 4G Band 12 (700 MHz), Band 17 (700 MHz), Band 28 (700 MHz), Band 13 (700 MHz),
Band 20 (800 MHz), Band 26 (850 MHz), Band 5 (850 MHz), Band 19 (850 MHz),
Band 8 (900 MHz), Band 4 (1700 MHz), Band 3 (1800 MHz), Band 2 (1900 MHz),
Band 25 (1900 MHz), Band 1 (2100 MHz), Band 39 (1900 MHz)
Power Class
Automower
®
Connect 2G Power Class 4 (for GSM/E-GSM) 33 dBm
Power Class 1 (for DCS/PCS) 30 dBm
Automower
®
Connect 4G Power Class 3 23 dBm
1438 - 003 - 08.09.2020 Operation - 3
To Next Page
Loading...
Need help?
General
