6 Applicable to US/CA market
6.1 Compliance requirements
FCC ID: XPYUBX18ZO01 (Automower
®
Connect
2G/4G)
The device complies with part 15 of the FCC Rules.
Operation is subjected to the following 2 conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
WARNING: To comply with RF
exposure requirements, please maintain a
separation distance of at least 20 cm / 7
inches from any part of the product.
Models with a hatch: The supplied label shall be
attached to the product according to figure below.
Models without a hatch: The supplied label shall be
attached to the product according to figure below
To Next Page
Loading...
Need help?
General
