22 - English
3. INSTALLATION
Best position for the boundary wire
The boundary wire should be laid so it:
• Forms a loop around the working area for Auto-
mower. Only an original boundary wire must be
used. This is tinned and has a high quality insula-
tion to withstand the dampness in the ground.
• Maintains a maximum distance of 100 ft from
Automower in the entire working area.
• Ideally not longer than 1600 ft.
• The boundary wire is laid at different distances
from obstacles depending on what the working
area borders. The picture below shows how the
boundary wire should be routed around the
working area and around obstacles.
Boundaries for the working area
If a high obstacle, for example a wall or fence,
borders the working area, the boundary wire should
be laid 14" from the obstacle. This will prevent
Automower from colliding with the obstacle and
reduce body wear.
3012-688US
35 cm
3012-824
To Next Page
Loading...
