36 - English
3. INSTALLATION
9. Connect the guide wire to the boundary wire with
the help of a solderless coupler:
• Insert the ends of the boundary wire in the right
respective left-hand holes on the connector.
• Insert the end of the guide wire in the centre
hole.
• Press down the button on the connector fully.
10. Staple down/bury the connector in the lawn.
IMPORTANT INFORMATION
The function of the guide wire varies
depending on how the working area appears.
It is therefore recommended to test the
installation with the help of the function Test
IN (3-2-4), see page 55.
3012-835
To Next Page
Loading...
Need help?
General
