16 - English
Fig. 1
7 Muffler
Muffler
D
C
E
H
F
G
7.1 Dismantling
WARNING!
Do not touch the muffler until it has
cooled. Risk of burn injuries.
1. Remove the cylinder cover.
2. Remove the screw (A) and the muffler cover (B).
3. Remove the bolts (C) and pull out the:
- muffler (D),
- gasket (E),
- cooling plate (F).
4. Remove the screw (G) and pull out the spark ar-
rester (H).
7.2 Cleaning and inspection
Clean all components and check the following:
1. That the spark-arrester is intact.
2. That the muffler and muffler mounting are not
cracked or in any way defect.
3. That the gasket is undamaged.
CAUTION!
Replace the gasket if it is damaged. The
gasket has to be fitted correctly against
the muffler.
7.3 Assembly
1. Clean the contact surfaces to the gasket, cooling
plate and cylinder.
2. If the chainsaw is fitted with a spark-arrester, refit it.
See Figure 1.
3. Fit the cooling plate, gasket and muffler to the cylin-
der. See Figure 1.
4. Finger-tighten the two screws and then screw the
screws fully. See Figure 1.
To Next Page
Loading...
