English - 21
10 Starter
10.1 Dismantling
1. Loosen the four screws holding the starter to the
crankcase. Lift the starter off the chainsaw. See
Figure 1.
2. Pull out the handle 20-30 cm (A) and take out the
cord from the slot in the starter pulley (B). See
Figure 2.
3. Rotate the starter pulley anticlockwise until the ten-
sion on the pulley is released. See Figure 2.
4. 130: Unscrew the central bolt (C) with integrated
washer. Lift up the starter pulley (D). See Figure 3.
135: Unscrew the central bolt (C) with integrated
washer. Lift up the starter pulley (F), spring (G) and
pulley (H).
5. If the starter cord is to be replaced, cut it off and
pull out the ends from the handle and starter pulley
using pointed pliers.
6. If the spring is to be replaced, remove the spring
(E).
10.2 Cleaning and inspection
1. Clean all components.
2. Check the following for nicks and cracks:
- Starter cord.
- The dogs on the starter pulley.
- That the pawls on the flywheel are intact and that
the spring is back towards the centre and moves
freely.
- The easy starter spring (only 135).
3. Grease the spring in the starter pulley
10.3 Assembly
WARNING!
If the spring is tensioned on the starter
pulley it can fly up and cause personal
injury.
1. If a new spring is to fitted, make sure that the spring
is placed against the bottom of the starter chassis.
130: Place the starter pulley against the spring (E)
and attach the screw (C). See Figure 3.
135: Place the pulley (H) against the spring (E). Put
the spring (G) in the pulley. Put the pulley (F) over
the spring and attach the screw (C). See Figure 3.
2. If a new rope is to be fitted, push the free end in the
hole in the starter pulley. Take hold of the end with
pointed pliers inside the pulley and pull out the rope.
Tie a double knot. Pull the rope through the starter
handle and tie a double knot. See Figure 4.
3. Grease the starter pulley bearing and spring.
Fig. 1
Starter
Fig. 2
Fig. 3
Fig. 4
C
E
D
135
C
F
G
H
To Next Page
Loading...
