Husqvarna H130 Mark II - Throttle Trigger Lockout, Throttle Trigger and Spring; Dismantling

English - 19
9 Throttle trigger lockout, throttle trigger and spring
9.1 Dismantling
1. Remove the cylinder cover, air filter, air filter holder
and clutch cover.
2. Remove the screw (A) holding the antivibration ele-
ment (B). See Figure 1.
3. Remove the antivibration element (B). See Figure 1.
4. Remove the chain catcher (C). See Figure 1.
5. Remove the antivibration element (D). See Figure 1.
6. Remove the screw (E) holding the antivibration ele-
ment (F). See Figure 2.
7. Remove the throttle wire (G). See Figure 3.
8. Remove the fuel hose (H) and the suction hose (I)
from the carburettor. See Figure 3.
Throttle trigger lockout, throttle trigger and spring
Fig. 2
Fig. 3
Fig. 1
G
I
H
P
E
F
A
B
C
D