Husqvarna H130 Mark II - Flywheel; Dismantling the Flywheel

24 - English
Flywheel
12 Flywheel
12.1 Dismantling
The ignition module can be left in place if you are simply
removing the flywheel.
1. Remove the cylinder cover.
2. Remove the starter unit and the air guide plate.
3. Clean and remove any dirt around the spark plug.
Unscrew the spark plug and fit the piston stop 575
29 36-01 in spark plug hole. See figure 1.
4. Loosen the screws holding the ignition module but
do not remove them.
5. Remove the flywheel nut.
6. Remove the screws (A), pawls (B), springs (C) and
washers (D). See Figure 2.
7. A special tool (502 51 49-02 )from Husqvarna is
required to dismantle and assemble the flywheel.
Center the tool on the crankshaft. Select the
appropriate screw, supplied with the tool, and fit the
screws in the holes for the start hooks. See Figure
3.
Fig. 1
Fig. 2
Fig. 3
A
B
C
D