Husqvarna H130 Mark II - Piston and Cylinder; Dismantling the Piston and Cylinder

38 - English
Piston and cylinder
18.1 Dismantling
1. Remove:
- Cylinder cover
- Spark plug
- Air filter and air filter holder
- Starter unit and air guide plate
- Ignition module
- Flywheel
- Clutch cover
- Clutch
- Muffler
- Anti-vibration element
- Oil system
2. Detach the fuel hose and return hose.
3. Detach the throttle wire.
4. Remove the tank unit and front handle
5. Remove the carburettor and the manifold
6. Remove the five screws holding the crankcase to
the cylinder. See Figure 1.
7. Remove the cylinder. See Figure 2.
CAUTION! Exercise care so that dirt
and foreign particles do not get into
the crankcase.
18 Piston and cylinder
Fig. 2
Fig. 1