English - 9
The tools listed here are service tools intended for use on the chainsaw in question. In addition to these tools, a
standard set of hand tools is required.
15 16 17
18
Service tools
Item Description Used for Article number
1
Piston stop Locking the crankshaft 575 29 36-01
2a
Cover plate, exhaust Sealing the exhaust port 502 54 11-02
2b
Cover plate, inlet Sealing the intake system 502 52 48-01
2c
Cover plug, inlet Compression test/cylinder 578 02 13-01
2d
Spacing sleeve (2 needed for test) To fill the distance 502 50 45-01
3
Pressure testing device Produce pressure when leakage testing 531 03 06-23
4
Puller Pulling bearing of crankshaft 531 00 48-67
5
Flywheel puller kit Dismantling of the flywheel 502 51 49-02
6
Adjustment screwdriver Adjustment of the carburettor 530 03 55-60
7
Adjuster kit 3 pcs Adjustment of the carburettor 585 07 17-01
8
Pressure test adapter Pressure testing cylinder 503 84 40-02
9
Feeler gauges ignition gap Air gap tool 502 51 34-02
10
Tachometer Checking engine rpm 502 71 14-01
11
Adjustment screwdriver Adjustment of the carburettor 501 60 02-03
12
Assembly pliers Assembly of spark plug cap 502 50 06-01
13
Hook for fuel filter Removing fuel filter 502 50 83-01
14
Assembly fixture Dismantling/assembling of the chainsaw 502 51 02-01
15
T-handle Torx T10 Dismantling/assembling of the chainsaw 588 52 41-01
15
T-handle Torx T20 Dismantling/assembling of the chainsaw 588 59 27-01
15
T-handle Torx T25 Dismantling/assembling of the chainsaw 502 71 27-01
15
T-handle Torx T27 Dismantling/assembling of the chainsaw 502 71 27-03
15
T-handle Torx T30 Dismantling/assembling of the chainsaw 502 71 31-01
16
T-handle Allen key For M5 bolts 502 50 18-01
17
Ring squeezer Piston ring squeeze tool 589 55 57-01
18
Worm spring tool Worm spring install/removal tool 589 86 13-01
19
Special tool clutch Clutch removal tool 530 03 11-12
20
Ignition checker Spark strengh check 501 97 64-01
21
Crankshaft installation tool Mounting bearing on crankshaft 502 50 30-18
19 20 21
To Next Page
Loading...
