Hussmann SMG8B - Page 11

P/N 3018126_E 1-7
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
SMG8B & SSG8B
4. Remove screws at top of rear door frame.
The bottom screws do not need to be
removed.
5. Pull back the top of the door frame
approximately 2 inches. This will allow
clearance for removal of the stainless steel
top liner and trim pieces.
6. Some models have a Phillips truss head
screw holding the stainless steel liner to
the trim. These screws are visible from the
rear of the merchandiser to the side of the
door frame. These must be removed.
7. Remove stainless steel top liner by
grabbing the rear flange and pulling back.
Note: It is possible to access the adjusting
bolt by using a small swivel socket without
removing the stainless top liner. To do
this, the stainless steel trim and foam
noted in Step 8 must be removed.
8. Remove stainless steel trim pieces and
foam insulation on each side of the door
frame.
REMOVE 2 SCREWS
AT TOP OF DOOR FRAME
(IN DOOR TRACKS)
STAINLESS STEEL TRIM
(FOAM INSULATION IS
UNDER TRIM)
PHILLIPS
TRUSS
HEAD
SCREW
STAINLESS
STEEL
LINER
PULL TOP OF DOOR FRAME
BACK AND REMOVE TOP
STAINLESS STEEL LINER
STAINLESS
STEEL
TOP
DOOR FRAME
ADJUSTING
BOLT
SET
SCREW