10-36 109706 10/08
15. Be sure that adjuster is free to move up and down.
16. Tighten the adjuster bolt until the chain just becomes tight, making sure that the deck
stays tight against the 3" block.
17. Tighten the adjuster bolt jam nut to prevent the adjuster bolt from moving (FIG. 65).
18. Tighten the hardware holding the chain and adjuster onto the deck lift arm.
19. Go to the right rear of the tractor.
20. Make sure that there is still slack in the chain. If not, loosen the two nuts on the block
holding the threaded rod until there is slack in the deck lift chain (FIG. 65).
21. Tighten the appropriate nut until the chain just becomes tight, making sure that the deck
stays tight against the 3" block.
22. Tighten the other nut on the opposite side of the block, and jam them tightly together
against the block.
FIG. 63 FIG. 64
FIG. 65 FIG. 66
FIG. 67
NUT
CHAINS
DECK LIFT THREADED ROD
DECK LIFT
NUT
NUT
THREADED ROD
CHAIN
HA
RDW
ARE
JAM NUT
5/16" BOLT
ADJUSTER
1"
1"
DECK LIFT ROD
LIFT BLOCK
To Next Page
Loading...
Need help?
General
