Huvitz Excelon - Rotation Worm & Worm Wheel Replacement

EXCELON
CPE-4000 Maintenance Ⅱ -
26
9. Rotation Worm & Worm Wheel Replacement
1. Open the Main Cover.
2. Remove the Edger left side cover
3. Disconnect all connectors.
4. Remove three screws and separate Rotation Worm Ass’y.
5. Loosen setscrews shown in below picture.
6. Remove Stepping Motor then separate Rotate Worm as below picture.
7. Replace it with a new one.
Rotation Worm Ass’y
M4 Bolt
M4 setscrew
Step 5
Rotation Worm
M4 setscrew
Step 6
Rotation Bearing Spacer
Rotation Motor Plate
Rotation Motor Plate Fixer
Rotation Worm Ass’y
Connectors
M5 Bolt
(Step 4)
Step 3, 4