HW Group STE 2 - SMS Tab

To Next Page

To Previous Page

STE2

SMS tab

With the Wiﬁ turned off, only the power-on option is shown:

Remote SMS gateway

• Enable – Turns on the SMS sending function. For sending, the SMS alarm action must be set

at the sensor or input.

• SMS Gateway Address – IP address where “HWg-SMS-GW3” is located through which the device

will send SMS. It can be set including service - typically /service.xml

• Port – The TCP port on which the gateway listens.

• Username – User name for authorization in SMS GW.

• Password – Password for authorization in SMS GW.

• SMS + Ring When Alarm – Enables sending a SMS and then dialing the number.

SMS Test Log

In this section, the SMS gateway settings can be tested.

• Test SMS – Sends a test text message to the speciﬁed Phone number.

• Test Call – Dials the speciﬁed Phone number.

• Debug log window – Shows the communication with the SMS gateway.

WWW interface