Hy-Gain MK2 - Final Assembly Checklist

Final Assembly 1. Check the distances between elements as shown in Figure 6.
C
h
ec
kli
s
t
2. Check to ensure all elements lie in the same plane and will be
p
er
p
endicular
(
at 90 de
g
rees
)
to the mast when installed.
3. Check the exposed element lengths against the dimensions shown in
Figure 6. Check both sides of each element. Ensure that the trap
ca
p
s are firml
y
seated.
4. Check the tightness of each element tubing clamp. You should not be
able to turn an element that is securel
y
clam
p
ed with a lar
g
er
5. Securel
y
ti
g
hten all bolts used in the element-to-boom brackets.
6. Securely tighten all bolts used in the phasing tube and beta tube as-
semblies.
7. Ensure that all trap drain holes and tubing slots are facing the
ground.
-17-/
(
-18-