2.4
OPTIONAL EQUIPMENT CONTROLS
LASER ON / OFF Pressing this key will cause the LASER to turn on or off. The red LED indicates that the LASER will be on.
*** SHUTTLE BUNDLING CONTROLS ***
SHUTTLE BUNDLING
OPEN
Pressing this key will open the shuttle bundling clamp. It will stop and hold its position if the key is released.
SHUTTLE BUNDLING
CLOSE
Activating this push button (LED is on) before entering AUTO MODE will allow the shuttle bundling clamp to
work in conjunction with the shuttle vise. The clamp will remain stationary in AUTO MODE if the push button
is not activated.
*** INFEED BUNDLING CONTROLS ***
INFEED BUNDLING
OPEN
Pressing this key will open the infeed bundling clamp. It will stop and hold its position if the key is released.
INFEED BUNDLING
CLOSE
Activating this push button (LED is on) before entering AUTO MODE will allow the infeed bundling clamp to
work in conjunction with the infeed vise. The clamp will remain stationary in AUTO MODE if the push button
is not activated.
*** OUTFEED BUNDLING CONTROLS ***
OUTFEED BUNDLING
OPEN
Pressing this key will open the outfeed bundling clamp. It will stop and hold its position if the key is released.
OUTFEED BUNDLING
CLOSE
Activating this push button (LED is on) before entering AUTO MODE will allow the outfeed bundling clamp to
work in conjunction with the outfeed vise. The clamp will remain stationary in AUTO MODE if the push button
is not activated.
*** NOTE ***
1. Make sure that the height of the bundling arm will not create a collision with the head.
2. The bundling clamps need to be moved out of the way when material is to be top loaded.
Refer to Section 7 for full details of Bundling Options.
To Next Page
