Hydac ETS 3000 Series - English

2 ETS 3000 IO-Link
Stand: 28.04.2020 HYDAC ELECTRONIC GMBH Mat. Nr.: 669904 D
Table of Content
Preface .................................................................................................................... 4
1 Safety Information ....................................................................................... 5
2 Exclusion of liability .................................................................................... 5
3 Warranty ....................................................................................................... 5
4 Security ......................................................................................................... 5
4.1 Symbols and Notes ................................................................................................. 5
4.2 Intended use / foreseeable misuse ......................................................................... 6
4.3 Obligation of the operator before start-up ............................................................... 6
4.4 Personnel selection and qualification; fundamental obligations .............................. 6
4.5 Organisational measures ........................................................................................ 7
5 Functions of the ETS 3000 .......................................................................... 7
6 Installation .................................................................................................... 7
6.1 General installation notes ........................................................................................ 7
6.2 Additional installation instructions ........................................................................... 8
7 Controls of the ETS 3000 ............................................................................ 9
8 Operation modes ......................................................................................... 9
8.1 SIO mode ................................................................................................................ 9
8.2 SDCI mode.............................................................................................................. 9
9 Parameterisation ........................................................................................ 11
9.1 Manual parameterisation on the device ................................................................ 11
9.2 Parameterisation in SDCI mode ............................................................................ 11
10 Reading the digital display ....................................................................... 12
11 Output Signals ........................................................................................... 14
11.1 Switching outputs .................................................................................................. 14
11.1.1 Two-point mode - Switch point setting (SP) ..................................................................... 14
11.1.2 Window mode - Window function setting (Fno / Fnc) ....................................................... 15
11.2 Setting ranges for the switching outputs ............................................................... 16
11.3 Analogue output .................................................................................................... 16
12 Basic Settings ............................................................................................ 17
12.1 Main menu ............................................................................................................ 17
12.2 Add-on functions ................................................................................................... 18
12.3 Changing the basic settings .................................................................................. 19
13 Resetting the peak values ......................................................................... 19