ETS 3000 IO-Link 7
Stand: 28.04.2020 HYDAC ELECTRONIC GMBH Mat. Nr.: 669904 D
4.5 Organisational measures
The user manual must always be kept accessible at the place of use of the measuring
system.
In addition to the user manual, generally applicable legal and other binding accident
prevention and environmental protection regulations must be paid attention to and must
be mediated.
The respective applicable national, local and system-specific provisions and
requirements must be paid attention to and mediated.
It is mandatory for the operator to inform personnel on special operating features and
requirements.
The personnel instructed to work with the measuring system must have read and
understood the user manual, especially the chapter 4 Security, prior to commencing
work.
The nameplates and any prohibition or instruction symbols applied on the measuring
system must always be maintained in a legible state.
Repairs may only be undertaken by the manufacturer or a facility or person authorized
by the manufacturer.
5 Functions of the ETS 3000
The ETS 3000 is available with an integral sensor probe and with an external temperature
sensor probe.
Depending on the model, the instrument has the following functions:
Supports IO-Link specifications V1.1 and V1.0
Supports SIO mode
Display of the switching states in SIO mode
Mode display (SIO or SDCI)
Adaptation to the corresponding application using specific parameter settings
Display of the actual temperature in °C or °F.
Display of the lowest value, peak value or a set switch point
Switching of the switching outputs in accordance with the temperature and the pre-
set switching parameters
Analogue output
Program enable
6 Installation
6.1 General installation notes
The ETS 3000 with integral sensor probe can be screwed directly into a hydraulic block via
the male thread (G1/2 A ISO 1179-2 , (DIN 3852)). The temperature sensor is built into the
stem before the thread. In order to perform correct measurements, ensure the probe is
immersed in the flow of the fluid.
The ETS 3000 with external sensor probe is wall mounted using the clamp, which is
available as an accessory (see chapter 19.2 Mechanical connection).
To ensure optimal positioning, the unit can be rotated 340° about its long axis, and the
display and key pad can be rotated through 270°.
To Next Page
