ETS 3000 IO-Link 11
Stand: 28.04.2020 HYDAC ELECTRONIC GMBH Mat. Nr.: 669904 D
9 Parameterisation
The temperature switch can either be programmed manually via the device keys or via the
IO-Link interface by means of any IO-Link compatible master configuration tool (according
IO-specifications V1.1). IO-Link specifications V1.0 are as well supported.
Should the read parameter sets from the device not be accepted, we recommend to carry
out a plausibility check of the parameter set.
For detailed information on IO-Link device parameters, factory defaults, process and
diagnostic data, supported standard system commands as well as additional HYDAC
device specific system commands for the various product versions (part numbers), please
refer to the corresponding IODD (IO Device Description).
You will find the link for download of the IODD on our homepage at:
(http://www.hydac.com/uk-en/products/sensors/show/Material/Index.html)
Products Sensors Produkt search
Entering the part number (9xxxxx) the corresponding ZIP file appears
As a further additional data source for IODDs the IODD finder can be used at:
(https://ioddfinder.io-
link.com/#/productvariants?vendorName=%22HYDAC%20ELECTRONIC%20GmbH%22)
9.1 Manual parameterisation on the device
ETS 3000 can be parameterised via the operation keys on the device. Menu navigation,
please see chapter 12 Basic Settings.
9.2 Parameterisation in SDCI mode
The temperature sensor can be parameterised in the SDCI mode using the IO-Link
interface by means of any IO-Link compatible master configuration tool (according IO
specifications V1.1). IO-Link specifications V1.0 are as well supported.
The configuration parameters of the IODD can be found in chapter 0
Anhang / Annex: IODD Einstellparameter / IODD Setting Parameters.
To Next Page
