Operating Instructions: 4-4
FUEL MUST MEET THESE REQUIREMENT:
1. Clean, fresh, unleaded gasoline.
2. Octane rating of 87 (R+M)/2 or higher.
3. Research Octane Number (RON) 90 Octane Minimum.
4. Gasoline up to 10% ethyl alcohol, 90% unleaded is acceptable.
5. Methyl Tertiary Butyl Ether (MTBE) and unleaded gasoline belnd (max 15% MTBE
by colume) are approved.
6. Do not add oil to gasoline.
7. Do not overl fuel tank.
8. Do not use gasoline older than 30 days.
NOTE: E15, E20 AND E85 ARE NOT APPROVED AND SHOULD NOT BE
USED; EFFECTS OF OLD, STALE OR CONTAMINATED FUEL ARE NOT
WARRANTABLE.
START-UP PROCEDURE
1. Perform all daily periodic maintenance as specied in this Owner’s Manual.
2. Connect a garden hose to supply water to the truckmount. If the pump-in feature is
used on your system, push the “PUMP-IN” switch to the “ON” position.
3. Connect the cleaning wand or tool to the length of hose required to perform the
cleaning job.
4. Start the truckmount with:
a. The throttle cable in the “IDLE” position.
b. The “PUMP CLUTCH” switch can be in the “ON”, or “OFF” position.
5. After the engine starts, allow the truckmount to run in “IDLE” for 2 - 3 minutes to
warm up.
Never clean when the Titan 625 is in the “IDLE” mode. Failure to follow this
caution may result in serious component or engine damage.
6. Turn the throttle cable all the way out.
7. Press the “PUMP CLUTCH” switch to the “ON” position for carpet cleaning, upholstery
cleaning or for high pressure washing.
8. If the Automatic Pump-Out is included in your system’s conguration, press the
“AUTO PUMP-OUT” switch to the “ON” position.
To Next Page
Loading...
