4 USAGE AND OPERATION
11
4.2.3. Temperature setting
In the main interface press " " or “ “ and the current mode target-temperature flashes,
then press " " to increase the temp. value, or press " " to decrease it.
Press " " can save setting parameter and back to the main interface;
Press " " can not save setting parameter but back to the main interfaces
Attention If there is no operation for 5s system would remember parameter setting and
back to the main interface.
For example:
Cooling target temperature
Press " " or
“ “ to change
the value
Press " " to save
value setting
4.2.4. Clock setting
In the main interface press " " twice Hours start to flashing, and press “ “ to increase
value or press " " to decrease value and press " " to save setting:
At the same time, minute start to flashing, press " " to increase value or press " " to
decrease value and press " “ to save setting.
Press " " can not save setting parameter and back to main interface.
Attention If there is no operation for 5s system will remember parameter setting and
back to the main interface.
For example:
To Next Page
Loading...
