Hydropool Hot Tub - Filter and Ice-Bucket Lid Installation; Mood Lighting System Operation; Safety Hardcover Locks; Optional Cover Remover

H Y D R O P O O L I N D U S T R I E S
14
FILTER/ICE-BUCKET LIDS
The filter and ice-bucket covers provided match the finish of your Hydropool hot tub. As the
covers are identical to each other, simply place over either opening for a finished appearance.
MOOD LIGHTING
STANDARD MOOD LIGHTING
Press the ‘light’ pad on the topside control to turn the light on and off.
LED MOOD LIGHTING OPTIONAL - FACTORY INSTALLED
(INCLUDING GARDEN FX & HYBRID FEFX LED/FIBER-OPTIC SYSTEMS)
Press the ‘light’ pad on the topside control to start the following LED lighting modes. Pressing the ‘light’ pad on/off within
3 seconds cycles through the various ‘light shows’. When the LED lighting is turned off for more than 5 seconds, then
turned back on, the system will resume the last ‘light show’.
Description of Light Shows:
• Mode 1 – Synchronous colour change
• Mode 2 – Freeze mode, freezes on selected colour blend from above mode (gives unlimited colour blend selection)
• Mode 3 – solid colour blue
• Mode 4 – solid colour green
• Mode 5 – solid colour red
CHANGING BULBS & LENSES
The coloured light lenses supplied with your hot tub (not required for units with optional LED lighting) simply push over
the existing clear light lens.
SAFETY HARDCOVER LOCKS
The safety hard cover is designed to open away from the control area, however, if the hot tub is symmetrical in dimension,
the cover can be oriented to open in either direction. Simply place the cover on the hot tub, pull the straps down so that
they are fully extended, then release slightly so that there is approximately 6 mm (1/4 in.) of slack. Mark the position on
the cabinet, and fasten the receiver clip with the screws provided. Always ensure the safety hard cover is in place and
locked whenever the hot tub is not being used.
OPTIONAL COVER REMOVER
Hydropool offers several different devices to assist in the removal of the safety hard
cover. Please refer to the instructions supplied with your particular cover remover
for installation. For further information, contact your local Hydropool dealer.