H Y D R O P O O L I N D U S T R I E S
39
WATERFALL CONTROL OPTIONAL
If your hot tub was ordered with the optional waterfall feature, then you will have a waterfall flow control valve. The
waterfall feature was designed to provide a gentle cascade of water over the neck and shoulder area. Simply turn the top
of the control clockwise for more water flow, and counterclockwise for less water flow.
DIVERTER VALVE
When your HYDROPOOL hot tub is equipped with a diverter valve,
it allows you to direct the flow of the water so that it increases the
power of the jets on the CAPTAINS CHAIR or on the LOUNGER, or a
combination of the two. Simply turn the valve left or right.
Always: return the valve handle to the middle position before
exiting the hot tub to ensure that there is air and water flow
to the ozone jet and ice bucket/filter niche drains for proper
performance.
JET INSERT REMOVAL & REPLACEMENT
BLASTER, PULSATOR, MASSAGE, POWER MASSAGE/
SPINNER, MEDIUM & MEDIUM PULSATOR JET
TO REMOVE:
• Turn the jet conter-clockwise to unclip & pull out of socket.
TO RE-INSTALL:
• Push the jet into the socket until it snaps into place, ensuring the
square pin on the back of the jet lines-up with the groove in the
socket flange.
To Next Page
Loading...
