H Y D R O P O O L I N D U S T R I E S
21
STANDBY / DRAIN ASSIST
The standby/drain assist feature stops the system from
operating automatically, allowing for convenient filter
cartridge removal and for safe draining of the hot tub. The
following pads must be pressed within 3 seconds of each
other.
Press then the or
pad - the display will
flash .
All functions will turn off, but the pump low speed can be
activated (by pressing the pad) to facilitate draining the
hot tub - the display will show DRN.
Press any pad other than the pad to return the system
to normal operation.
See DRAINING YOUR HOT TUB – p. 47 - for detailed
instructions.
MOOD LIGHTING
STANDARD MOOD LIGHTING
Press the pad on the topside control to turn the light
on and off.
LED MOOD LIGHTING OPTIONAL – FACTORY INSTALLED
Press the pad on the topside control to start the
selection of LED lighting modes. Pressing the pad on/off
within 3 seconds cycles through the various ‘light shows’.
When the LED lighting is turned off for more than 5
seconds, then turned back on, the system will resume the
last ‘light show’. For complete description of ‘light shows’,
see MOOD LIGHTING – p. 14
The system will automatically turn off the mood lighting
after 4 hours.
BLOWER OPTIONAL – FACTORY INSTALLED
/
Press this pad to turn the blower on and off.
The system will automatically turn off the blower after
15 minutes.
PURGE CYCLES BLOWER ONLY
The system automatically activates the blower for 30
seconds at the beginning of each filter cycle to introduce
fresh, sanitized water into these plumbing circuits.
OZONATOR OPTIONAL
The ozonator operates during FILTER CYCLES and CLEAN UP
CYCLES only
FREEZE PROTECTION
If the temperature sensor detects a drop to 44˚F within the
heater chamber, the system automatically activates the
pump to provide freeze protection. The pump will operate
until the temperature reaches 45˚F, and then will continue
to operate for an additional 4 minutes before returning to
normal system mode.
To Next Page
Loading...
