H Y D R O P O O L I N D U S T R I E S
33
TOPSIDE PANEL LOCK FEATURES
There are two modes you can choose from: Full lock or
Partial lock. Full lock means that all keypad functions are
locked. Partial lock means that the basic functions of the
spa will remain accessible (pumps and light). When control
pad is locked, the icon will be displayed.
LOCKING/UNLOCKING THE TOPSIDE PANEL
2
1 Press and hold Pump 2 key for 5 seconds.
2 The display will show LOCP, with ’P‘
representing Partial lock.
3 Release key and keypad will be in Partial lock
mode. Keep key pressed down for 5 more
seconds if you want to be in Full lock mode.
The LOCF message will then be displayed.
When control pad is locked, all automatic functions of
the system run as usual. If a key is pressed down, a LOCP
or LOCF message will be displayed for 1 second. To unlock
the keypad, simply press and hold Pump 2 key again for 5
seconds.
STANDBY /DRAIN ASSIST
The standby/drain assist feature stops the system from
operating automatically, allowing for convenient filter
cartridge removal or for safe draining of the hot tub. To put
the system in standby, press and hold the ‘Mode’ key for 5
seconds. All functions will turn off, but P1 low speed can be
activated (by pressing the ‘P1’ key) to facilitate draining the
spa. Press and hold the ‘Mode’ key for 5 seconds to return
the system to normal operation. The system automatically
shuts off P1 low speed after 1 hour, and exits ‘Standby’
mode after 3 hours, resuming automatic operation. If
the heater is on while the ‘Standby’ mode is activated, the
pump will continue to operate for a 30 second cool down
period, during which time the STBY message will flash
on/off. See DRAINING YOUR HOT TUB - p. 47 for detailed
instructions.
MOOD LIGHTING
STANDARD MOOD LIGHTING
Press the pad on the topside control to turn
the light on and off.
LED MOOD LIGHTING OPTIONAL – FACTORY INSTALLED
Press the pad on the topside control to start the
selection of LED lighting modes. Pressing the pad
on/off within 3 seconds cycles through the various ‘light
shows’. When the LED lighting is turned off for more than 5
seconds, then turned back on, the system will resume the
last ‘light show’. For complete description of ‘light shows’,
see MOOD LIGHTING – p. 14
The system will automatically turn off the mood lighting
after 4 hours.
BLOWER OPTIONAL - FACTORY INSTALLED
Press this key to turn the blower on and off. The
system will automatically turn off the blower
after 15 minutes.
OZONATOR OPTIONAL
The ozonator operates during FILTER CYCLES and CLEAN-UP
CYCLES only (starts 5 minutes after filter cycle begins).
FREEZE PROTECTION / SMART WINTER MODE
An onboard sensor continuously monitors the ambient
air temperature inside the control pack. If at anytime the
temperature drops below 55˚ F (13˚ C) the system activates
the Winter mode for the next 24 hours. In this mode, if the
pump has not been turned on in the last 2 hours (whether
manually or automatically), the system will automatically
activate P1 low speed for 1 minute to circulate warm water
through the plumbing. While the pump is operating in
this mode, the Filter indicator on the display will flash
on/off.
To Next Page
Loading...
