H Y D R O P O O L I N D U S T R I E S
37
STANDBY / DRAIN ASSIST
The standby/drain assist feature stops the system form
operating automatically, allowing for convenient filter
cartridge removal and for safe draining of the hot tub.
The
following pads must be pressed within 3 seconds of each
other:
Press then STBY will flash on the display
All functions will turn off, but P1 low speed can be activated
(by pressing the pad) to facilitate draining the hot tub.
Press any pad other than the pad to return the system
to normal operation. See DRAINING YOUR HOT TUB - p. 47
for detailed instructions.
MOOD LIGHTING
STANDARD MOOD LIGHTING
Press the pad on the topside control to turn the light
on and off.
LED MOOD LIGHTING OPTIONAL – FACTORY INSTALLED
Press the pad on the topside control to start the
selection of LED lighting modes. Pressing the pad
on/off within 3 seconds cycles through the various ‘light
shows’. When the LED lighting is turned off for more than 5
seconds, then turned back on, the system will resume the
last ‘light show’. For complete description of ‘light shows’,
see MOOD LIGHTING – p. 14
The system will automatically turn off the mood lighting
after 4 hours.
BLOWER OPTIONAL – FACTORY INSTALLED
1st press – turns on high speed – the icon is displayed
while the blower is on
2nd press – turns on low speed
3rd press – turns off blower – no icon displayed when
blower is off
The system will automatically turn off the blower after 15
minutes.
OZONATOR OPTIONAL
The ozonator operates during FILTER CYCLES only. The display
will show the O
3
icon while the ozonator is operating.
FREEZE PROTECTION
If the temperature sensor detects a drop to 44˚F within
the heater chamber, the system automatically activates all
pumps to provide freeze protection. The pumps will operate
until the temperature reaches 45˚F, and then will continue
to operate for an additional 4 minutes before returning to
normal system mode.
To Next Page
Loading...
