Hypertherm Powermax30 Field Service Bulletin

4 Powermax30/30 XP/30 AIR Field Service Bulletin 805430
Power Cord Replacement
Kit 228210 contents (CSA)

The 120 V/15 A CSA plug adapter (229132) and the 240 V/20 A CSA plug adapter
(229133) must be ordered separately from the power cord kit.
Kit 228140 contents (CE)
Kit 228143 contents
Replace the power cord
Remove the rear panel
1. Set the power switch to OFF (O), disconnect the power cord from the power source, and disconnect the gas supply.
2. Remove the 2 screws from the handle on the top of the power supply.
3. Slightly tip the front and rear panels away from the power supply so that you can get the edges of the handle out from
underneath them. Remove the handle, and set it and the 2 screws aside.
Figure 1
Part number Description Quantity
229135 Power cord assembly: Powermax30, Powermax30 XP, and
Powermax30 Air L6-20P
1
Part number Description Quantity
229120 Power cord assembly: Powermax30 and Powermax30 XP CE 1
Part number Description Quantity
008389 Strain relief: 0.428 – 0.546 black vinyl 1

Hypertherm Powermax30 Specifications

General

Brand	Hypertherm
Model	Powermax30
Category	Welding System
Language	English