HOW TO CLEAN A LIFT TRUCK
WARNING
Compressed air can move particles so that they
cause injury to the user or to other personnel.
Make sure that the path of the compressed air is
away from all personnel. Wear protective goggles
or a face shield to prevent injury to the eyes.
CAUTION
Units may be washed with a non-heated pressure
washer. Steam cleaning is not recommended in
most instances, as condensation may form in
electrical components causing damage or erratic
behavior.
NOTE: Lift trucks used in paper applications may
need cleaning beyond what is described here.
Please refer to Paper Application section in the
applicable Operating Manual and to available
Service Gram/Bulletin for more detail.
If it becomes necessary to clean the fork lift, follow
the guidelines listed below.
1.
Assure truck components are cool before
starting the cleaning procedure.
2.
Disconnect the battery. If an electric truck,
remove the traction battery.
3.
Remove accumulated debris using a
compressed air line and nozzle.
4.
Lightly spray a non-corrosive cleaning agent
onto the areas to be cleaned. This will help
loosen grime, so close contact direct spraying
will not be necessary.
5.
Be sure to avoid directing the spray into
electrical panel compartment. Ensure over-
spray does not come in contact with electrical
components; DO NOT spray water directly at
electrical components, wiring connectors or
electrical enclosures. Even sealed connectors
may allow water egress under pressure or if
connector is damaged.
6.
Avoid spraying in areas containing electrical
components such as:
• Floor Plates
• Battery Compartment
• Dash/cowl assembly
• Armrests with electrical components
7.
Clean the battery compartment by using a
clean cloth to wash the battery with water. Dry
with compressed air. Care should be taken to
keep moisture at a minimum as some units
have a traction or hydraulic motor directly
below the battery compartment.
8.
DO NOT pressure wash the battery. DO NOT
use hot water. For cleaning traction batteries,
refer to the Battery section of the Service
Manual.
9.
DO NOT pressure wash lift chains, sheaves or
load rollers in the mast assembly. Refer to the
Chains, Sheaves and Load Rollers maintenance
section in the Service Manual for proper
cleaning procedures.
10.
After cleaning, immediately run the lift truck to
dry out components.
8000 SRM 1541 General
5
To Next Page
Loading...
