Hytera DMR - Radio Overview; Programmable Keys


Installation
Before you install the radio in a vehicle, be sure to read
the following instructions carefully:
Instructions


The radio operates with negative grounded power
supply of 13.2±15
％
V only. Please check polarity and
voltage of the power supply on vehicle before you
install the radio.


Please check how long the screws will extend from the
bottom surface of radio, before you install the radio.
Be sure to drill mounting hole with caution, to avoid
damage of the vehicle wiring and parts.


Please connect the supplied antenna and power cord
to the radio, before you install the radio in the bracket.


Install the radio with Hytera supplied mounting bracket,
to avoid radio loose in case of accidents. The loose
radio may cause bodily injury.


Install the radio in a location where it’s easy to reach
the front panel controls.


Please make sure there’s sufcient space at back of
the radio for wiring.


When the fuse for DC power cord needs replacement,
i t m u s t b e r e p l a c e d b y a f u s e w i t h t h e s a m e
specication.
Installation Tools


Electric drill


Cross head screwdriver


Hex socket sleeve (used for 4.8*20mm self-tapping
screws)