Troubleshooting
Phenomena Analysis Solution
The equipment can not be
powered on.
The power cord may be unconnected. Connect the power cord correctly.
During receiving signals, the
voice is weak, discontinuous or
totally inactive.
The volume may be set to a low level.
Increase the volume by rotating the Vol-
ume Control knob clockwise.
The antenna may get loose or may be
improperly installed.
Power off the radio, re-install the antenna
and power on the radio again.
The speaker may be blocked or damaged.
Clean surface of the speaker. If the prob-
lem can not be solved, contact your dealer
or authorized service center for inspection
and repair.
You can not communicate
with other members in Analog
mode.
The frequency or signaling may be incon-
sistent with that of other members.
Set your TX/RX frequency or signaling to
the same as that of other members.
You may be too far away from the group
members.
Move towards other members. And make
sure that you are within the communication
range.
You can not communicate with
other members in Digital mode
although there is receiving
indication.
Your ID may be inconsistent with that of
other members. Consequently, the digital
carrier can be received but can not be
demodulated.
Set your ID to the same as that of other
members.
To Next Page
Loading...
Need help?
General
