Hytorc LITHIUM Series Operation Manual

29
INSTALL SOCKET
CONVENTIONAL TORQUE SETUP
• Set the Torque Value using the left button h and right button
i.
• Output units may be displayed in lb-ft, N-m, kgf-m or %. (See output unit settings under the ADMIN menu)
• The direction arrow and rotating nut icon reflect the direction associated with the specific fastener type. (The fastener
type may be set under the Operation – Fastener Type menu: Right-Hand, Left-Hand, HYTORC NUT and HYTORC
Washer).
• Power on the tool, adjust the settings and select
fastener. For conventional torque applications the
fastener will be right or left hand.
• If necessary set the speed switch to Rundown to quickly
run down the nuts until flush against the flange.
• Prior to applying torque, position a back wrench to
prevent the back nut from turning during tightening.
• Place the socket on the nut, making sure to fully engage
the nut.
• Make sure the reaction arm is firmly abutted against a
stationary object before applying torque.
(CONT’D.)

Hytorc LITHIUM Series Specifications

General

Brand	Hytorc
Model	LITHIUM Series
Category	Tools
Language	English