LITHIUM SERIES® Electric Torque Tool (BTM and BTM-DOC Models) Operations Manual
32
INSTALL THE HYTORC WASHER DRIVER
• The Tool is easily configured for tightening bolts where
the HYTORC Washer is used.
• Identify the appropriate size HYTORC Washer Driver.
• Slide the washer driver over the square drive and spline
while aligning the thumb screw with the flat on the spline.
• Tighten the thumb screw to secure the Driver.
• Challenge the driver to make sure it is securely attached.
. BOLTING WITH THE HYTORC WASHER
To Next Page
Loading...
